But because of its time period, the built-in assembler only ever understood up to 80286 instructions, so the day you wanted a 386 and its 32-bit registers you were sent off to an external assembler anyway.
Or you just prefixed the instructions with "db $66", et voila your instructions were 32bit. I wrote a lot of inline 32bit assembly that way in TP 6.0 and 7.0.
True, but that still gave you access to only a subset of the 80386 instructions.
For the others, you had to write them entirely in unreadable hexadecimal, adding a data-size prefix was not enough.
By far the most useful were the 32-bit addressing modes. With your method, you could access those by adding just a "db $67" prefix, but then the addressing modes would have been greatly obfuscated by the 80286 notation, so that would not have been much better than writing the entire instruction in hexadecimal.
Comments
Or you just prefixed the instructions with "db $66", et voila your instructions were 32bit. I wrote a lot of inline 32bit assembly that way in TP 6.0 and 7.0.
True, but that still gave you access to only a subset of the 80386 instructions.
For the others, you had to write them entirely in unreadable hexadecimal, adding a data-size prefix was not enough.
By far the most useful were the 32-bit addressing modes. With your method, you could access those by adding just a "db $67" prefix, but then the addressing modes would have been greatly obfuscated by the 80286 notation, so that would not have been much better than writing the entire instruction in hexadecimal.