Unfortunately I cant find the pics of the build at the moment. It's a stock SGI 550 case so nothing special done to the case. I replaced the PIII Dual Xeon board with an Asus Threadripper board w/ 1920x CPU, 32GB ECC RAM, Radeon Pro W5700, 1TB NVMe, 10Gb NIC. Daily driver running Void Linux Musl.
The mod to the PSU was needed because the IEC inlet was practically at the edge of the PSU housing which is partly obstructed by the edge of the SGI case. I could have modded the case by cutting the steel but I didn't want to cut up a unique case when the PSU is easier to replace. So I opened the supply, unscrewed the IEC inlet, de-soldered the leads from the inlet to the board then soldered in a length of 18 AWG cord. I covered the IEC inlet with a piece of 16 gauge (~1.2mm) aluminum with a 16mm hole for a cable gland and two screw holes for mounting with machine screws and nuts. The cord is secured by a metal cable gland and terminates to an in-line IEC socket. NOTE: I did replace the X and Y caps across the factory inlet with new ones I soldered to the PSU board with the cord.
Comments
Would you mind sharing a picture?
Unfortunately I cant find the pics of the build at the moment. It's a stock SGI 550 case so nothing special done to the case. I replaced the PIII Dual Xeon board with an Asus Threadripper board w/ 1920x CPU, 32GB ECC RAM, Radeon Pro W5700, 1TB NVMe, 10Gb NIC. Daily driver running Void Linux Musl.
The mod to the PSU was needed because the IEC inlet was practically at the edge of the PSU housing which is partly obstructed by the edge of the SGI case. I could have modded the case by cutting the steel but I didn't want to cut up a unique case when the PSU is easier to replace. So I opened the supply, unscrewed the IEC inlet, de-soldered the leads from the inlet to the board then soldered in a length of 18 AWG cord. I covered the IEC inlet with a piece of 16 gauge (~1.2mm) aluminum with a 16mm hole for a cable gland and two screw holes for mounting with machine screws and nuts. The cord is secured by a metal cable gland and terminates to an in-line IEC socket. NOTE: I did replace the X and Y caps across the factory inlet with new ones I soldered to the PSU board with the cord.