You could power inductively, perhaps. So create a fluctuating magnetic field to deliver power to a coil (which is on the puck), then let a microprocessor on the puck control the flow of current to different coils (also on the puck) which are then pulled towards permanent magnets in the PCB.
Hm. You got me thinking about this: another layer below that can send a 'charge' pulse to a coil on the puck to charge a super cap. Bonus points if you can turn that into a levitation mechanism.
This is along the lines of what I was thinking initially but more by reacting to the instantaneous current induced in the coil rather than a charge/discharge action.
Where the ring launcher works by counter emf that evolves in the conductor, a tuned emf (like for RFID chips) could be made with specific properties. Eg. it might only respond to certain frequency bands and possibly (?) allow for both repulsive and attractive forces by either maintaining or inverting the exciter phase in the board.
You could let a microcontroller on the puck control the allowed currents. If you do this sufficiently fast, you can multiplex over different pucks on the board.
Creating a tuned oscillator could be interesting too, but could also turn out to be too heavy, in terms of component weight.
Comments
You could power inductively, perhaps. So create a fluctuating magnetic field to deliver power to a coil (which is on the puck), then let a microprocessor on the puck control the flow of current to different coils (also on the puck) which are then pulled towards permanent magnets in the PCB.
Hm. You got me thinking about this: another layer below that can send a 'charge' pulse to a coil on the puck to charge a super cap. Bonus points if you can turn that into a levitation mechanism.
This is along the lines of what I was thinking initially but more by reacting to the instantaneous current induced in the coil rather than a charge/discharge action.
Basically a small version of the ring launcher - https://www.youtube.com/watch?v=V690VphqTwg
Where the ring launcher works by counter emf that evolves in the conductor, a tuned emf (like for RFID chips) could be made with specific properties. Eg. it might only respond to certain frequency bands and possibly (?) allow for both repulsive and attractive forces by either maintaining or inverting the exciter phase in the board.
I'm absolutely itching to give this a shot but I really should be concentrating on other things right now.
You could let a microcontroller on the puck control the allowed currents. If you do this sufficiently fast, you can multiplex over different pucks on the board.
Creating a tuned oscillator could be interesting too, but could also turn out to be too heavy, in terms of component weight.
Have through hole vias everywhere and turn your PCB into the surface of a tiny airhockey table?
Neat! Not too much pressure though or you'll be peeling your robots off the ceiling :)