That's what I was expecting as well. Guessing that "connector" an industry term that I'm just not aware of. Seems like some pre-made adapter patterns for ETL's from browsing the docs.
Same, I was expecting some 3D printing, maybe some experimentation about how much spacing is needed between pins for insulation and how large the contact surfaces should be etc.
Comments
Was hoping for something about rapid prototyping of electrical connectors.
This is a fun story in that vein: http://www.bigmessowires.com/2016/06/04/db-19-resurrecting-a...
Low supply of DB 19 connectors? I'll bet this is why there are 10k Teslas that can't be delivered right now.
In the end, data is transported as electrical current so it is not completely off :)
That's what I was expecting as well. Guessing that "connector" an industry term that I'm just not aware of. Seems like some pre-made adapter patterns for ETL's from browsing the docs.
Same, I was expecting some 3D printing, maybe some experimentation about how much spacing is needed between pins for insulation and how large the contact surfaces should be etc.
I was excited.
I actually would love a service that did this for something mortally/individually affordable.